How to write a cursive “a”
A cursive “a” is an anticlockwise bowl that closes on itself, then a straight downstroke on the right side, finished with a shallow upstroke that leaves the baseline. The whole body sits between the x-height line and the baseline — nothing of the a rises above the second guide.
- Open the bowl anticlockwiseBegin just under the x-height line, a little right of where the bowl will close, and sweep anticlockwise: left, down, round the bottom and back up.
- Close it, then come downMeet the start of the first stroke, then rise to the x-height and pull a straight stem back down to the baseline.
- Exit towards the next letterLeave the baseline in a short upstroke aimed at the height where the next letter starts. This is the stroke the Finish score watches: 19 of the 100 marks, and the one that decides whether the next letter can join.
Mistakes that cost marks on the “a”
- The bowl never closesAn open bowl reads as a “u” and costs marks on the Shape score, because half the model's path stays uncovered.
- The stem leans to the rightThe downstroke should run parallel to the right side of the bowl. A leaning stem makes a whole word look unstable.
- The exit stroke stops deadA flat finish leaves no room for the next letter; ease the pen out and upward as you leave the baseline.
Words to practise after this letter
Once the single letter feels automatic, write these words. They all pass through “a” and test whether the exit stroke still lines up with the next letter.
- an
- cat
- am
- and
How the score is worked out
The a has no ascender and no descender, so every mark comes from the space between two lines — a small error reads as a large percentage. Watch Finish more than Shape: the bowl is easy to draw, but the a is usually the first letter where people stop joining.
How the cursive a is built
The lowercase a is a c that gets closed. Start on the baseline, push up and over to the right to make the bowl, come back down to the baseline, then take the stem straight down from the top of the bowl and finish with the exit stroke that lifts off the baseline.
Say it as you write: over, down, up, out. Four beats. If you can say it, your hand can do it.
Where the a goes wrong
- The bowl is too narrow. A narrow bowl leaves no room for the stem, so the whole letter leans. Make the bowl about as wide as it is tall.
- The stem is drawn before the bowl. Then the bowl has to fit around it and the letter ends up square. Bowl first, always.
- The exit stroke stops at the baseline. The a has to leave the paper on the baseline, moving right, otherwise the b or t after it has nowhere to start.
Practise it
The pad is set to letter a when you arrive from this page. Do three traced attempts with Trace on, then click Trace again to turn off the grey guide and do three more without the model. A score in the eighties on an unguided a is ready to move on.
The a is the first letter of the push-stroke group: see c, o, d, g and q.