How to write a cursive “b”
A cursive “b” starts with an upstroke that climbs past the x-height and loops back down through the same line, then reverses at the baseline into a round bowl that closes halfway up and leaves the baseline to the right. The loop belongs to the ascender space; the bowl belongs to the x-height space.
- Climb into the loopStart on the baseline, rise to the right and carry the line up past the x-height into the ascender space.
- Close the loop on the way downCurve left at the top, come back down across your own upstroke, and stop at the baseline.
- Round the bowl and exitReverse at the baseline into a bowl that closes at about half the x-height, then ease out to the right. The Finish score watches this stroke.
Mistakes that cost marks on the “b”
- The bowl is too narrowA narrow bowl turns the letter into an h, and the Shape score drops sharply because the right side of the model stays empty.
- The loop crosses too lowThe loop must close on itself: if it crosses too low, the letter reads as a six and the shape cannot be marked as a b at all.
Words to practise after this letter
Once the single letter feels automatic, write these words. They all pass through “b” and test whether the exit stroke still lines up with the next letter.
- be
- book
- big
- black
How the score is worked out
Two thirds of the b's model path is the loop, so a loop that is too small or too fat will sink the Shape score even when the bowl is perfect. If your score stalls around 65, raise the loop before you touch anything else.
How the cursive b is built
The b starts high. Begin at the top line, go up and left into a narrow loop, come straight down to the baseline, bounce back up to the x-height, and make one small hump that finishes with an exit stroke on the baseline.
Two beats: loop, hump. The loop is thin, the hump is round, and the two look nothing alike — that difference is what makes the letter readable.
Where the b goes wrong
- The loop is wide and round. A wide loop turns the b into a shape that reads as h or l. The loop should be narrow enough that you can draw it in one fast movement.
- The hump starts at the baseline. Without the bounce back up to the x-height there is no hump at all, just a second downstroke.
- The hump is too big. It has to sit between the x-height line and the baseline, not between the top line and the baseline.
Practise it
Open the pad on b and trace three times with Trace on, then click Trace again to turn off the grey guide and draw it three more with the model gone. The Finish score is only 19 of the 100 marks here, but on a b it decides everything that follows: a letter that does not leave on the baseline will not join to an e or an r, so treat the last stroke as part of the shape rather than an afterthought.