How to write a cursive “g”
A cursive “g” opens with the closed anticlockwise bowl of an a, then continues from the baseline down into the descender band, loops left and back up, closes through its own stem and exits to the right at the baseline.
- Bowl first, exactly like an aDraw a closed a bowl: anticlockwise from just under the x-height, finishing on the baseline.
- Drop into the descenderFrom the baseline, continue straight down to the descender line without lifting the pen.
- Close the tail and exitLoop left, come back up through the tail, close it and finish with a baseline exit.
Mistakes that cost marks on the “g”
- The tail is too shortA short tail leaves the descender band empty and turns the letter into a q with a wiggle.
- The loop does not closeThe tail must close through its own stem before leaving. An open tail reads as a printed g dropped into the word.
Words to practise after this letter
Once the single letter feels automatic, write these words. They all pass through “g” and test whether the exit stroke still lines up with the next letter.
- go
- again
- big
- dog
How the score is worked out
The g is the letter where the two halves of the score separate most clearly: the bowl can be flawless while the tail is too shallow, and a shallow tail costs nearly half the model's path. Look at the ink below the baseline before you change anything in the bowl.
How the cursive g is built
Bowl first, exactly like an a: up, over, down to the baseline. Then instead of stopping, take the stem down below the baseline into a loop that closes back on the baseline and exits right.
Where the g goes wrong
- The tail turns into a straight hook. The descender is a closed loop, not a stick.
- The loop sits too far right. It should hang almost under the bowl, not trail off behind it.
- Bowl and loop the same size. The bowl is small and round; the loop is taller and narrower.
Practise it
Pair it with a: the first half of the two letters is identical. If your g is wrong at the top, your a is too.