How to write a cursive “z”
A cursive “z” begins with a small rightward curve at the x-height, runs a diagonal down to the bottom of the x-height band, curves right again and then drops below the baseline into a short loop that closes and exits.
- Top curveStart at the x-height, curve right and slightly up.
- Diagonal and bottom curveSwing down and across in a diagonal to the bottom of the x-height band, then curve right again.
- Descender tail and exitDrop below the baseline, loop and close, then exit.
Mistakes that cost marks on the “z”
- The descender is missingA z with no tail sits on the baseline and leaves the descender band empty.
- The diagonal is too longIf the diagonal crosses the full height of the band the letter looks like a slash; it runs from just under the x-height down to the bottom curve.
Words to practise after this letter
Once the single letter feels automatic, write these words. They all pass through “z” and test whether the exit stroke still lines up with the next letter.
- zoo
- zero
- zap
- prize
How the score is worked out
The z is the only letter that contains a diagonal, so the shape score reacts to angle rather than to width. If your score stays in the sixties, the diagonal is usually starting too far left.
How the cursive z is built
The z starts on the baseline, runs flat to the right at x-height, then drops diagonally back to the baseline, and closes with a small loop that exits right.
It is the only lowercase letter with a horizontal top, which makes it the easiest one to recognise and the easiest one to draw mechanically.
Where it goes wrong
A top that slopes makes the z look like a r with a tail. A missing bottom loop leaves it unable to join.