CursivePlay

Cursive letter Y

Cursive Letter “y”: How to Write It, Step by Step

The y is a u with a descender loop tacked onto the second stem. It is the last descender letter, and the one that most often spoils a signature.

cursiveFour-line cursive practice sheet

How to write a cursive “y”

A cursive “y” is a u followed by a descender: down from the x-height to a round bottom, up to the x-height, down again into the second stem and straight on into the descender band, where it loops left, closes through itself and exits at the baseline.

  1. Start with a uWrite a u: down, round bottom, up to the x-height, down again to the baseline.
  2. Carry the second stem downKeep going past the baseline, straight down to the descender line.
  3. Close the tail and exitLoop left, come back up through the tail, close it and exit on the baseline.

Mistakes that cost marks on the “y”

  • The tail stops at the baselineA short tail leaves the descender band empty and the y reads as a u with a wiggle.
  • The loop does not closeThe loop must close on itself; an open tail breaks the letter into two pieces.

Words to practise after this letter

Once the single letter feels automatic, write these words. They all pass through “y” and test whether the exit stroke still lines up with the next letter.

  • you
  • my
  • day
  • yes

How the score is worked out

Because the y contains a u, any u problem appears twice in the same letter. Fix the u first; the y then only needs a longer tail and a closed loop.

How the cursive y is built

Downstroke to the baseline, up to the x-height, down again — and this time keep going below the baseline into a loop that turns left and comes back up to finish on the baseline with an exit.

It is a u with a descender, and that is the only difference.

Where it goes wrong

The loop is usually either missing or too tight. If the tail is a straight stick the letter reads as u with a scratch under it.

Questions about the letter “y”

What makes the “y” different from a “u”?

The u': down, round bottom, up, down again; then the tail: loop below the baseline and come back up. The tail's loop is what makes the y, not the height of the stems.

How deep should the y's tail go?

It goes to the descender line, so y spends nearly a third of its stroke length below the baseline. A short tail is the single most common fault.