How to write a cursive “s”
A cursive “s” starts just below the x-height line, hooks left and immediately curves down the left side to well below the x-height, then swings right and up to the x-height before falling into a short exit on the baseline. It has no straight segment and no loop.
- Small hook at the top rightBegin just under the x-height and curve left into a small open hook, not a closed circle.
- Reverse curve downwardSweep down the left side, keeping the curve open, and bottom out just above the baseline.
- Turn and exitSwing right and up to the x-height, then come down to the baseline for the exit.
Mistakes that cost marks on the “s”
- The top hook is missingWithout the top hook the s becomes a closed o or a c, and the upper-left of the model stays empty.
- The bottom does not turnThe bottom stroke must return to the right; if it stops at the baseline the s cannot join, and half the exit marks are gone.
Words to practise after this letter
Once the single letter feels automatic, write these words. They all pass through “s” and test whether the exit stroke still lines up with the next letter.
- is
- so
- see
- small
How the score is worked out
The s is the one letter where a flat segment shows up instantly in the shape score: every part of it curves. If your score sits below 60, check the height of the bottom turn first — most s's are written too tall at the bottom.
How the cursive s is built
Start just above the baseline, curve up and left to the x-height, round the top to the right, come down through the middle, and close with a small loop at the bottom that exits right.
The s is the letter with no straight line in it, which is why it feels different from everything around it.
Where it goes wrong
Making the top too pointed turns the s into a lightning bolt. Leaving off the bottom loop means it cannot join to the next letter.