How to write a cursive “t”
A cursive “t” rises from the baseline past the x-height to just under the ascender line, comes back down to the baseline, and carries a horizontal cross-stroke that crosses the stem above the x-height on the way back up.
- Up, but not the full ascenderStart on the baseline and rise to just under the top line — not all the way.
- Back down to the baselineCome straight back down to the baseline, keeping the stem vertical.
- Cross it, then exitCross the stem horizontally just above the x-height, then leave with a short exit.
Mistakes that cost marks on the “t”
- The stem is too shortA stem that stops at the x-height turns the t into a small mess that could be an l or an i; the upper part of the model stays empty.
- The cross-stroke is diagonalThe cross-stroke should be horizontal and pass through both sides of the stem. A diagonal cross looks like a tick.
Words to practise after this letter
Once the single letter feels automatic, write these words. They all pass through “t” and test whether the exit stroke still lines up with the next letter.
- to
- it
- time
- that
How the score is worked out
The t's height is the same as the cross-stroke height of a printed t, so most people write it too short. The model's stem stops under the top line, which means a short t and a full-height l are told apart by nothing except height.
How the cursive t is built
Start on the baseline, up to just below the top line, straight down to the baseline, exit right. Then lift the pen and cross the stem with a short horizontal bar.
The stem stops short of the top line — that half-height is what separates a t from an l.
Where it goes wrong
A stem that reaches the top line turns the t into an l. A crossbar drawn in the middle of the stem instead of at the x-height makes it look like a plus sign.