How to write a cursive “r”
A cursive “r” is a short upstroke to the x-height, immediately followed by a small rounded arm that lifts to the x-height and then falls vertically to the baseline, finishing with a short exit.
- Short upstrokeRise from the baseline to the x-height in a single short stroke.
- Shoulder, not a flat lineRound the shoulder to the right and let it lift a little above the x-height.
- Straight drop and exitDrop straight to the baseline and add a short exit.
Mistakes that cost marks on the “r”
- The arm lies flatA flat arm turns the r into a tick; the arm should rise above the x-height before dropping straight.
- The final drop is curvedThe downstroke must not curve back to the right, or the letter reads as an unfinished n.
Words to practise after this letter
Once the single letter feels automatic, write these words. They all pass through “r” and test whether the exit stroke still lines up with the next letter.
- are
- here
- run
- read
How the score is worked out
The r's arm is the only part of the letter that leaves the x-height band, so it is also the part that the shape score sees first. If your r looks like an n, the drop is curving; if it looks like a printed r, the arm is too flat.
How the cursive r is built
Downstroke from the x-height to the baseline, back up to the x-height, then a short shoulder that flicks right and comes back down to the baseline before the exit.
The r is a stem and a shoulder, not a hump. That distinction is the whole letter: a hump makes an n.
Where it goes wrong
Most written rs become an illegible up-and-down squiggle because the shoulder is too small to read. Make the shoulder wide enough to see, and make it sit at the x-height line, not in the middle of the band.