How to write a cursive “j”
A cursive “j” is a short stem that starts at the x-height line, comes down through the baseline into the descender band, loops left and back up, closes through the stem and finishes with a small exit; the dot goes above and slightly right of the top of the stem.
- Straight stem downStart at the x-height line and come straight down through the baseline.
- Loop below the baselineAt the descender line curve left, loop back up and close the tail through its own path.
- Dot last, then exitAdd the dot above the x-height, right of the stem, and leave with a short exit.
Mistakes that cost marks on the “j”
- The tail is too shallowA tail that stops at the baseline turns the j into an i, and the whole descender part of the model is left empty.
- The dot is too highThe dot belongs above the x-height and slightly right of the stem; directly above makes the letter look like an exclamation mark.
Words to practise after this letter
Once the single letter feels automatic, write these words. They all pass through “j” and test whether the exit stroke still lines up with the next letter.
- jump
- just
- jog
- jelly
How the score is worked out
The j is a good test of whether you are slowing down at the turn: the tail is drawn on the way up, so a fast stroke leaves a sharp corner at the bottom. That corner is what the shape score notices.
How the cursive j is built
A straight downstroke from the x-height that carries on below the baseline into a loop turning left, back up to the baseline, exit right. The dot goes on last, above the stem.
The j is the i with a descender, and the only difference that matters is the loop below the line.
Where it goes wrong
Cut the descender short and it becomes an i. Loop it the wrong way and it reads as a g. Keep the loop narrow and hang it straight under the stem.